EPC1441PCB vs EPC1441PI8N Comparison
Detailed side-by-side comparison of EPC1441PCB by Altera and EPC1441PI8N by Altera. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.
Altera
EPC1441PCB
EPC1441PCB - Altera Enhanced Configuration Device for SRAM FPGAs
EPC1441PCB Obsolete
Specification Comparison
| Parameter | EPC1441PCB | EPC1441PI8N |
|---|---|---|
| Brand | Altera | Altera |
| Category | FPGA & CPLD | Memory ICs |
| Lifecycle Status | Obsolete | Last_time_buy |
| Stock Status | In Stock | In Stock |
| Unit Price (USD) | $2.18 | $3.55 |
| Device Type | Enhanced Configuration Device for SRAM FPGAs | β |
| Memory Density | 4,435,200 bits (~4 Mb) | β |
| Supported FPGA Families | ACEX 1K, APEX 20K, APEX II, FLEX 10K, FLEX 6000, FLEX 8000, Mercury | β |
| Programmability | In-system programmable via JTAG (IEEE 1149.1) | β |
| Configuration Interface | Altera serial/parallel configuration bus (nSTATUS, nCONFIG, DCLK, DATA) | Altera Serial (PS) configuration |
| Supply Voltage (VCC) | 3.3 V nominal | β |
| I/O Voltage Tolerance | 5 V tolerant | β |
| Package | PLCC-20 (Plastic Leaded Chip Carrier) | 8-pin PDIP (Plastic DIP, through-hole) |
| Mounting Type | Surface Mount / Socket | Through-hole (THT) |
| Operating Temperature | 0 C to +70 C (commercial) | -40C to +85C (industrial) |
| Configuration Mode | Automatic at power-up | β |
| Architecture | Flash memory + on-chip configuration controller | β |
| JTAG Support | Yes (IEEE 1149.1 boundary scan) | β |
| RoHS Status | [DATA_NEEDED: RoHS compliance status] | β |
| Lead-Free | [DATA_NEEDED: lead-free status] | β |
| Memory Type | β | OTP Configuration PROM (poly-fuse) |
| Memory Capacity | β | 440,800 bits (440 Kbit) |
| Supply Voltage VCC | β | 5.0 V nominal (4.75 V to 5.25 V) |
| Active Supply Current ICC | β | [DATA_NEEDED: typical active ICC] |
| Standby Supply Current ICCSTBY | β | approximately 50 uA |
| Programming Method | β | Off-board PROM programmer (poly-fuse OTP) |
| Configuration Time | β | <100 ms typical for FLEX10KA loading |
| Pin Count | β | 8 |
| Lead-Free / RoHS | β | Non-RoHS (legacy through-hole); check suffix for Pb-free option |
| Compatible FPGA Families | β | FLEX10K, FLEX10KA, FLEX6000, APEX20K series |
| Family Position | β | Top-of-family (largest density: 440Kb) |
| Programming Voltage | β | [DATA_NEEDED: VPP programming voltage] |
| Endurance | β | One-time programmable (no reprogram cycles) |