EPC2T32UCAF48 vs EPC2TC32UCF48 Comparison
Detailed side-by-side comparison of EPC2T32UCAF48 by Intel and EPC2TC32UCF48 by Intel. Compare key specifications, electrical parameters, packaging, lifecycle status, pricing, and availability to determine the best component for your design requirements.
Intel
EPC2TC32UCF48
EPC2TC32UCF48 - 1.6Mb FPGA Config PROM | Intel / Altera | TQFP-48
EPC2TC32UCF48 NrndSpecification Comparison
| Parameter | EPC2T32UCAF48 | EPC2TC32UCF48 |
|---|---|---|
| Brand | Intel | Intel |
| Category | Memory ICs | Memory ICs |
| Lifecycle Status | Active | Nrnd |
| Stock Status | In Stock | In Stock |
| Unit Price (USD) | $10.05 | $10.85 |
| Device Type | Configuration PROM for SRAM-based FPGAs | β |
| Memory Capacity | 32 Mbit | β |
| Interface | Serial / Parallel configuration; JTAG (IEEE 1149.1) ISP | β |
| Supply Voltage | 3.0 V to 3.6 V (3.3 V typical) | β |
| Configuration Modes | Serial, Parallel (8/16-bit) | β |
| JTAG Interface | 4-wire (TMS, TCK, TDI, TDO) | β |
| Cascade Support | Yes (nCASC pin for multi-device chains) | β |
| Operating Temperature | [DATA_NEEDED: operating temperature range] | 0C to +70C (commercial) |
| Package | QFP-48 (CAF48) | 48-pin TQFP (7x7 mm) |
| Mounting Type | Surface Mount | Surface Mount |
| MSL Level | [DATA_NEEDED: MSL rating] | [DATA_NEEDED: MSL rating] |
| RoHS Status | [DATA_NEEDED: RoHS compliance] | [DATA_NEEDED: confirm RoHS compliance] |
| Process Technology | CMOS non-volatile memory | β |
| Manufacturer | Intel (formerly Altera) | β |
| Series | EPC2 (Enhanced Configuration Device) | β |
| Memory Type | β | Non-volatile configuration PROM (CMOS Flash-based) |
| Memory Density | β | 1.6 Mbit (1.6 Mb / 32 Mbit raw) |
| Memory Configuration | β | Serial configuration bitstream storage |
| Supply Voltage (VCC) | β | 3.0 V to 3.6 V (3.3 V typical) |
| Supply Voltage (VCCIO) | β | 1.8 V / 2.5 V / 3.3 V (bank-level) |
| Output Drive Current (VCCIO) | β | [DATA_NEEDED: IOH/IOL at 3.3 V VCCIO] |
| Programming Interface | β | IEEE Std. 1149.1 JTAG (in-system programmable) |
| Configuration Interface | β | Altera serial PROM interface (DCLK, DATA, nCONFIG, nSTATUS, CONF_DONE) |
| Supported Configuration Modes | β | FPP, AS, PS, JTAG (mode dependent on target FPGA MSEL pins) |
| Daisy Chain Support | β | Yes (multi-device cascade for >16 Mbit FPGAs) |
| Maximum Cascaded Capacity | β | Up to 16 Mbit total across chain |
| Lead Free | β | [DATA_NEEDED: confirm lead-free] |